Mõõteseadmed ja tööriistad
- Arendusplaadid
- Laiendusplaadid ja tarvikud
- Tark kodu
- Komplektid
- Robotid
- Toide
- Andurid ja nende tarvikud
- Mootorid, rattad ja reduktorid
- Mootorite juhtmoodulid
- Ekraanid ja näidikud
- Juhtmevaba side moodulid
- Muundurid
- Nupud ja juhtkangid
- Pistikud ja pesad
- Mikrokontrollerid
- Programmaatorid
- Kaablid
- Komponendid
- Mõõteseadmed ja tööriistad
- MakerBeam
- Autoelektroonika
- Tööstuselektroonika
- Kirjandus
- Kingitused
- Kasutatud asjad
Kaablitangid
Crimping Tool: 0.1-1.0 mm² Capacity, 16-28 AWG
Using the Crimping Tool
Prepare the wire by stripping about 1/8" (3 mm) of insulation from the end. Place the wire in the crimp pin, lining it up so that the stripped portion lies between the inner set of tabs on the crimp pin, while insulated wire lies between the outer set of tabs.
Place the wire and crimp pin on the appropriate tooth of the tool’s die, making sure that the insulated end is on the raised and wider half of the tooth. The tabs should point toward the cavity on the other side of the die so that the tool bends them inward around the wire when it closes.
Close the jaws of the tool slowly and completely until they release. The tabs on a properly crimped pin should form one barrel around the wire conductors and another barrel for strain relief around the wire insulation.
Teile võib meeldida ka