Osutiga samm-mootor X27 näidikutele

These are often used in gauges for motorcycles and cars to replace the old-style fully-analog type. They have extremely fine step precision of about 1/2 a degree per step, 600 steps for single stepping, fast response for quick movements, and a range of  ~315° degrees. Their smooth motion makes good for small projects that need a dial indicator, and more precision motion than you may get with a needle gauge.

Since this is a bi-polar stepper motor you do need to have some sort of H-Bridge to drive it. If you have a microcontroller that can drive 200 ohm loads you might be able to use the direct pins without extra MOSFETs, just remember to include kickback/flyback protection diodes!

Note that the motor is quite 'weak', not good for moving anything but a light indicator. We include a red-line dial that fits nicely on top by pushing onto the needle shaft.

• Axial Force Maximum: 150N
• Axial Pull Force Maximum: 100N
• Radial Force Maximum: 12N
• Rotation Angle Maximum: 315°
• Coil Resistance: 260 ohm
• General Tolerance: ± 0.1 / ± 5°
• Rotation Angle Maximum: ~315°
• 600 steps per 'rotation' (315 degree rotation)

Dimensions:

• ​Motor Diameter: 32mm
• Motor Thickness (w/o pins): 9mm